hdfirmware

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-15660 addressed a code review comment

DEN-15628 changed the blood leak zero sequence counter from Z to G since Z is repeated twice in each zero sequence

DEN-15660, DEN-15721 added code to check the blood detection in treatment and service mode both

Merge branch 'staging' into DEN-15660-test_configuration_treatment_recovery

    • -7
    • +26
    /firmware/App/Modes/ModeTreatment.c
    • -3
    • +35
    /firmware/App/Services/Reservoirs.c
Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DEN-15556 to staging.

DEN-15556: Addressed code review comments.

DEN-15556: Fix to last.

DEN-15556: Stabilize pressures after UF rate change.

DEN-15556: Addressed issues for DEN-15556 re: not repeating used cartridge test and openeing VBA after door closed after cartridge install to prevent saline from leaking into the line.

DEN-15660, DEN-15809 updated the code

DEN-15660 uncommented the code

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

    • -2
    • +2
    /firmware/App/Controllers/DGInterface.c
    • -1
    • +1
    /firmware/App/Controllers/DialOutFlow.c
Merged DEN-15763 to staging.

DEN-15763: Addressed code review comments.

    • -2
    • +2
    /firmware/App/Controllers/DialOutFlow.c
DEN-15763: increased timeout period for dialysate prime state of pre-tx.

DEN-15763: adjusted timing of uf rate calculation to clean up logging issues.

    • -13
    • +22
    /firmware/App/Controllers/DialOutFlow.c
DEN-15660 disabled alarm 63 for testing

DEN-15763: Changed clear persistence behavior for illegal air trap alarm. Additional refinements to UF control start up.

    • -7
    • +24
    /firmware/App/Controllers/DialOutFlow.c
DEN-15763: Addressed code review comment.

    • -2
    • +5
    /firmware/App/Controllers/DialOutFlow.c
DEN-15763: set DG mode to fault if DG comm is lost.

    • -0
    • +5
    /firmware/App/Controllers/DGInterface.c
DEN-15763: Tuning of start of UF control per data.

    • -10
    • +9
    /firmware/App/Controllers/DialOutFlow.c
DEN-15763: more updates to start of UF control.

    • -5
    • +7
    /firmware/App/Controllers/DialOutFlow.c
DEN-15763: Addressed DEN-15779.

DEN-15763: Addressed DEN-15729.

DEN-15763: Addressed code review comment.

    • -2
    • +2
    /firmware/App/Controllers/DGInterface.c
DEN-15763: Additional fix for DEN-15763 to allow post-tx to drain reservoirs if DG was restarted (alarm 107).

    • -1
    • +3
    /firmware/App/Controllers/DialOutFlow.c
DEN-15763: Clear preserved POR bit for logging purposes after logged.