dgfirmware

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DENBUG-119 removed the transition from the service mode to ro permeate sample

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DENBUG-124

Merge branch 'staging' into DENBUG-124-chemical-disinfect-flush-cancel-water-path-running-too-fast

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DENBUG-116

DENBUG-116 merged staging

DENBUG-116 changed the transition from service mode to fault mode to be illegal

Merge branch 'staging' into DENBUG-124-chemical-disinfect-flush-cancel-water-path-running-too-fast

DENBUG-124 added code to reinitialize the drain parameters chemical disinfect, chemical disinfect flush and flush in cancel water path

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DENBUG-119

DENBUG-116 changed the code to only allow write to service, calibration, and system records when DG is in service mode

DENBUG-119 changed the operation modes table to prevent a mode transition from service mode to RO permeate sample mode

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DENBUG-112

DENBUG-112 updated the VectorCAST test cases

DENBUG-112 updated the VectorCAST test cases

DENBUG-112 changed the tare alarm limit in heat disinfect active cool mode

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

    • -1
    • +1
    /firmware/App/Modes/ModeHeatDisinfect.c
Merged DEN-16446 to staging.

Merge branch 'DEN-16446-dg-dev-test-clean-up-vectorcast' of ssh://dvm-linux02:7999/dg/dgfirmware into DEN-16446-dg-dev-test-clean-up-vectorcast

DEN-16446: Address DENBUG-105 to reset concentrate volume used when priming conc lines.

DENBUG-76 added code to not check the temperature sensors drift until a couple of minutes into R1 to R2

    • -1
    • +10
    /firmware/App/Modes/ModeHeatDisinfect.c
Merged staging to DEN-16446.