dgfirmware

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Merge branch 'DEN-14689-messaging-bugs' into develop

    • -11
    • +7
    /firmware/App/Controllers/DrainPump.c
    • -48
    • +63
    /firmware/App/Controllers/Heaters.c
    • -30
    • +45
    /firmware/App/Services/Reservoirs.c
    • -12
    • +2
    /firmware/App/Services/Reservoirs.h
    • -17
    • +17
    /firmware/App/Services/SystemComm.c
DEN-14689: sync msg_ids with msgdefs.h

    • -16
    • +20
    /firmware/App/Services/SystemComm.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

    • -2
    • +2
    /firmware/App/Controllers/FlowSensors.c
Merged DEN-13154 into staging.

Merge branch 'staging' into DEN-14689-messaging-bugs

Merge branch 'staging' into DEN-14763-dg_hd_dev-hd_dg_dvt-update-part-10

    • -11
    • +7
    /firmware/App/Controllers/DrainPump.c
    • -4
    • +3
    /firmware/App/Modes/ModeHeatDisinfect.c
    • -30
    • +45
    /firmware/App/Services/Reservoirs.c
    • -12
    • +2
    /firmware/App/Services/Reservoirs.h
DG-DEN-13154_Heparin Syringe Empty Position Incorrect
DG-DEN-13154_Heparin Syringe Empty Position Incorrect
DEN-13154: Added raw flow rates to DG flow broadcast messages.

    • -4
    • +6
    /firmware/App/Controllers/FlowSensors.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DEN-14834

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

In common.h to be used by both stacks.

In common.h to be used by both stacks.

Where did this go?

Where did this go?

DEN-14834 updated the code to just send the heater command in Idle and Drain if the primary heater is not on. Addressed the code review comments

    • -10
    • +0
    /firmware/App/Services/Reservoirs.h
Done.

Done.

Done.

Done.

Done

Done

Remove blank line.

Remove blank line.

Comments for these target flows should explain why they're here (instead of just getting flow from flow module).

Comments for these target flows should explain why they're here (instead of just getting flow from flow module).

What is the point of subtracting 0.0?

What is the point of subtracting 0.0?

DG-DEN-14834_RO Flow Drops TO Zero And CP Measured Speed 1500 Temporarily During Pre Treatment
DG-DEN-14834_RO Flow Drops TO Zero And CP Measured Speed 1500 Temporarily During Pre Treatment