dgfirmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

    • -2
    • +2
    /firmware/App/Controllers/FlowSensors.c
    • -1
    • +1
    /firmware/App/Modes/ModeHeatDisinfect.c
Merged DEN-15125

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

That's what it looked like when reviewed HD side. RESOLVED IN CODE WALKTHROUGH

That's what it looked like when reviewed HD side.

RESOLVED IN CODE WALKTHROUGH

DEN-16125 updated the concentrate pumps code to set the direction speed of the concentrate pumps when the measured speed is called

    • -2
    • +2
    /firmware/App/Controllers/FlowSensors.c
    • -2
    • +2
    /firmware/App/Modes/ModeHeatDisinfect.c
Merge branch 'staging' into DEN-15634-bad-fill-states-and-signal-updating-inconsistently

DEN-15634: code review comments.

Fixed!

Fixed!

For DG, it's not used (yet at least). But there are common macros that call this function, so had to change HD and DG versions of this function.

For DG, it's not used (yet at least). But there are common macros that call this function, so had to change HD and DG versions of this function.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Move blank line up one.

Move blank line up one.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Move blank line down one.

Move blank line down one.

DEN-15634: code review comments.

Where is outside used?

Where is outside used?

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

DEN-15125 addressed the compiler warnings

DEN-15634: fixed warnings

DEN-15634: fixed compiler error.

DEN-15634: added drain mode msg_id to publish.

DG-DEN-16125_DG Chem Flush DG Does Not Transition From Flush R1 TO R2 Drain R2 TO Cancel Water
DG-DEN-16125_DG Chem Flush DG Does Not Transition From Flush R1 TO R2 Drain R2 TO Cancel Water
DEN-16125 removed the code in chemical flush that was checking the drain timeout in some of the states

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DENBUG-59-fw-duplicate-alarms-occur-during-post-treatment-rinseback-and-block-workflow' into develop

DENBUG-59: Distinguish between alarms originating outside.

DENBUG-59: Added alarm properties to prevent alarm trigger while in rinseback or post-tx states.