dgfirmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

    • -2
    • +2
    /firmware/App/Controllers/FlowSensors.c
    • -1
    • +1
    /firmware/App/Modes/ModeHeatDisinfect.c
Merged DEN-15125

DEN-16125 updated the concentrate pumps code to set the direction speed of the concentrate pumps when the measured speed is called

    • -2
    • +2
    /firmware/App/Controllers/FlowSensors.c
    • -2
    • +2
    /firmware/App/Modes/ModeHeatDisinfect.c
Merge branch 'staging' into DEN-15634-bad-fill-states-and-signal-updating-inconsistently

DEN-15634: code review comments.

DEN-15634: code review comments.

DEN-15125 addressed the compiler warnings

DEN-15634: fixed warnings

DEN-15634: fixed compiler error.

DEN-15634: added drain mode msg_id to publish.

DEN-16125 removed the code in chemical flush that was checking the drain timeout in some of the states

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DENBUG-59-fw-duplicate-alarms-occur-during-post-treatment-rinseback-and-block-workflow' into develop

DENBUG-59: Distinguish between alarms originating outside.

DENBUG-59: Added alarm properties to prevent alarm trigger while in rinseback or post-tx states.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

    • -2
    • +2
    /firmware/App/Controllers/FlowSensors.c
    • -2
    • +2
    /firmware/App/Controllers/FlowSensors.h
DEN-15634: code review comments

Merge branch 'DIAL-273-need-override-for-dg.flow_sensors.measured_raw_dialysate_flow_lpm' into staging

DEN-15634: implemented drain mode broadcast overrides.

DEN-15634: fixed drain mode publish not being called. code review comments.

code review comments.

DEN-15634: code review comments

Merge branch 'staging' into DIAL-273-need-override-for-dg.flow_sensors.measured_raw_dialysate_flow_lpm

DEN-15634: implemented bad fill signal on fill and drain modes. Implemented drain mode broadcast

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merged staging

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DIAL-273-need-override-for-dg.flow_sensors.measured_raw_dialysate_flow_lpm' into develop

DEN-15570: fixed operation status event to be sent after updating currentMode.