dgfirmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Merged DENBUG-334

DENBUG-334 reverted the heat disinfect reservoir transfter target flow back 0.5 L/min

    • -1
    • +1
    /firmware/App/Modes/ModeHeatDisinfect.c
updated the code to initialize the variables in between the treatments without a need to power cycle the unit

    • -1
    • +1
    /firmware/App/Controllers/Thermistors.c
    • -1
    • +1
    /firmware/App/Modes/ModeHeatDisinfect.c
DG-DENBUG-334_Alarm 127 Low Venous Pressure Not Triggered When Back TO Back TX IS Run Without Power Cycle
DG-DENBUG-334_Alarm 127 Low Venous Pressure Not Triggered When Back TO Back TX IS Run Without Power Cycle
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged release/p1b/staging

    • -269
    • +283
    /firmware/App/Controllers/Pressures.c
Merged DENBUG-327

DENBUG-327 added code from staging

    • -269
    • +283
    /firmware/App/Controllers/Pressures.c
DG-DENBUG-327_Baro Sensor Data Refresh Staging
DG-DENBUG-327_Baro Sensor Data Refresh Staging
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DENBUG-327

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DENBUG-327 updated the VectorCAST test cases

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merged DENBUG-327

DENBUG-327 updated the baro sensor mfg CRC check

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Done

Done

DENBUG-327 added code to make the baro sensor MFG CRC as LSB

Do we need to shift CRC bits to lsb position?

Do we need to shift CRC bits to lsb position?