TemperatureSensors.c

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14999: merged staging

  1. … 5 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 8 more files in changeset.
DEN-14999 updated the code based on the alarms table update

  1. … 8 more files in changeset.
DEN-14999: Removed alarm 203 (dg POST adc rail check for pressure sensors). Removed alarm 116 (dg temperature sensors adc rail check). Removed adc temperature sensors from alarm 115 (dg temperature sensors range check).

  1. … 1 more file in changeset.
Merge branch 'staging' into DEN-14646-fpga-alarm-properties-and-timing-3

  1. … 4 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 17 more files in changeset.
DEN-14763 addressed the code review comments and added inlet water conditions to the heat disinfect active cool

  1. … 7 more files in changeset.
DEN-14646 Update per code review comments.

  1. … 5 more files in changeset.
Merge branch 'staging' into DEN-14646-fpga-alarm-properties-and-timing-3

# Conflicts:

# firmware/App/Controllers/TemperatureSensors.c

  1. … 1 more file in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 7 more files in changeset.
DEN-14834 updated that get target primary heater function to accomodate the changes from pre-treatment. Removed the range check from the drain pump measured RPM

  1. … 4 more files in changeset.
DEN-14646 - Remove checking the error counter for persistent alarms that previously generated alarms based upon the read counter and the error counter.

  1. … 3 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14645 expanded the TDi/TRo drift limit temporarily

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 22 more files in changeset.
Merge branch 'staging' into DEN-14559-dg_hd_dev-hd_dg_dvt-update-part-8

  1. … 4 more files in changeset.
DEN-14559 updated the code to be able request POST by the Dialin user. Updated the chemical disinfect flush to be able drain the reservoirs all the time

  1. … 10 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 9 more files in changeset.
DEN-13946 Corrections per code review

  1. … 6 more files in changeset.
DEN-13946 Make monitor functions for pressure, temperature, thermistors and load cells consistent. Address code review comments.

  1. … 3 more files in changeset.
DEN-14559 added functions to reset the POST states of the drivers that have a POST state machine for the command to request POST again

  1. … 12 more files in changeset.
DEN-14559 updated the cleaning modes with the SRS changes

  1. … 7 more files in changeset.
Merge branch 'staging' into DEN-13946-certain-temperature-sensors-trigger-wrong-alarm

  1. … 1 more file in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 23 more files in changeset.
DEN-14497 added the latest VectorCAST from PiSquare

Merge branch 'staging' into DEN-14497-dg_hd_dev-hd_dg_dvt-update-part-7

  1. … 23 more files in changeset.
Fixed merge conflicts.

  1. … 22 more files in changeset.
DEN-14497 updated the drain pump flow control algorithm. Fixed the inlet water pressure, temperature, conductivity alarm recovery in treatment modes. Updated chemical disinfect flush mode

  1. … 10 more files in changeset.
DEN-13946 Use typedefs for itterating over sensors.

  1. … 3 more files in changeset.
DEN-14497 updated the drain pump control for the flow and updating chemical disinfect is in progress

  1. … 5 more files in changeset.