Controllers

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14646 Updates per code review.

DEN-14817: fixed persistence holder to consider overriden park bit values

DEN-14817: added persistence holding for beta hw

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 13 more files in changeset.
DEN-14817: updated concentrate pump parking to not consider pump speed alarm until we have received a park bit

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 6 more files in changeset.
Merge branch 'DIAL-222-sys-request' into develop

DIAL-222: fixed heaters override reset.

DEN-14763 addressed the code review comments and added inlet water conditions to the heat disinfect active cool

  1. … 4 more files in changeset.
DEN-14646 Update per code review comments.

DEN-14646 Update per code review comments.

  1. … 2 more files in changeset.
Merge branch 'staging' into DEN-14646-fpga-alarm-properties-and-timing-3

# Conflicts:

# firmware/App/Controllers/TemperatureSensors.c

DEN-14646 - Remove code inserted for debugging. Enable FPGA clock speed check and watchdog check.

  1. … 2 more files in changeset.
DEN-14646 Use typedefs in voltages.c to improve debugging. Correct counting FPGA timeouts twice if write values ACK not received. Correct handling of emstat response status values.

  1. … 1 more file in changeset.
Merge branch 'DEN-14689-messaging-bugs' into develop

  1. … 5 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merge branch 'staging' into DEN-14763-dg_hd_dev-hd_dg_dvt-update-part-10

  1. … 6 more files in changeset.
DEN-13154: Added raw flow rates to DG flow broadcast messages.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 5 more files in changeset.
DEN-14834 updated the code to just send the heater command in Idle and Drain if the primary heater is not on. Addressed the code review comments

  1. … 4 more files in changeset.
Merge branch 'staging' into DEN-14834-ro-flow-drops-to-zero-and-cp-measured-speed-1500-temporarily-during-pre-treatment

DEN-14834 updated that get target primary heater function to accomodate the changes from pre-treatment. Removed the range check from the drain pump measured RPM

  1. … 2 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 1 more file in changeset.
DEN-14788: code review comments

DEN-14834 updated the code to not check the rejection ratio and CPo if the target fill is less than 550 mL. Updated the heaters code to make sure the stop heaters command stops the heaters unless a new start command is issued

  1. … 1 more file in changeset.
Merge branch 'DEN-14689-messaging-bugs' into develop

  1. … 2 more files in changeset.
DEN-14689: message naming synchronization.

  1. … 4 more files in changeset.
DEN-14646 Add buffer protection for emStat. Add NAK, CRC and timeout check for response to write actuators.

  1. … 1 more file in changeset.
Merge branch 'staging' into DEN-14646-fpga-alarm-properties-and-timing-3