ModeHeatDisinfect.c

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-15921, DEN-15916 changed the heat disinfect, heat disinfect active cool, and flush modes to send their start state via the events system

  1. … 4 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 10 more files in changeset.
Changed the heat disinfect transfer rate from 800 mL/min to 500 mL/min

Merge branch 'staging' into DEN-15660-test_configuration_treatment_recovery

  1. … 4 more files in changeset.
Merge branch 'DEN-15660-test_configuration_treatment_recovery' into develop

  1. … 1 more file in changeset.
DEN-15660, DEN-15781, added code to not check the dialysate temperature sensorswhen the dialysate flow is zero. DEN-15808, Added code to process the empty jug alarm

  1. … 2 more files in changeset.
Merge branch 'DEN-15802-no-dg-flow-rate-out-of-range-alarms-191-192-for-heat-disinfect-active-cool' into develop

# Conflicts:

# firmware/App/DGCommon.h

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merge branch 'DEN-15691-heat-disinfect-reservoir-leak-alarm-triggers-after-5s-when-srsdg-512-and-521-say-it' into develop

Timeout increased from 5 to 10 seconds

DEN-15691-heat-disinfect-reservoir-leak-alarm-triggers-after-5s-when-srsdg-512-and-521-say-it

Corrected comment alignment

DEN-15691-heat-disinfect-reservoir-leak-alarm-triggers-after-5s-when-srsdg-512-and-521-say-it

Undated 5second timeout to 10 seconds

DEN-15660, DEN-15727 removed the chemical disinfect flush complete date set from its complete state since it should only be updated if the sample passed

  1. … 1 more file in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 25 more files in changeset.
DEN-15367, DEN-15446 renamed the function that checks whether any of the inlet water conditions are active in a cleaning mode

  1. … 6 more files in changeset.
DEN-15446 added a function to check the status of the inlet water conditions and trigger the cleaning modes to transition to cancel water path

  1. … 6 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 5 more files in changeset.
DEN-15455 updated the code

  1. … 2 more files in changeset.
DEN-15367, DEN-15404 worked on the treatment recovery. Initial commit of the RO permeate sample mode

  1. … 12 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 19 more files in changeset.
DEN-15274 addressed the code review comments

  1. … 3 more files in changeset.
Merge branch 'staging' into DEN-15274-hd_dg_test_configuration_setup

  1. … 7 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 13 more files in changeset.
DIAL-251: DG changes for operation status event handling.

  1. … 13 more files in changeset.
DEN-15274 created another function to drain to a target volume in milliliters

  1. … 7 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 3 more files in changeset.
DEN-15265, DEN-15246 changed the heat disinfect's primary target temperature to 60 C prior to filling with water for the actual heat disinfct. Updated the code to properly exit the bad fill state of the gen idle mode once the bad sequence is finished

  1. … 1 more file in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 13 more files in changeset.
Merge branch 'staging' into DEN-15166-add-drain-pump-maxon-board-rpm

Merge branch 'DEN-15178-heat-disinfect-drain-timeout-transition-to-cancel-water-path-instead-of-cancel' into develop

# Conflicts:

# firmware/App/DGCommon.h

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces