Modes

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Merge branch 'DEN-15921-when-cap-is-open-dg-transition-to-cancel-basic-path-instead-of-cancel-water-path' into develop

  1. … 1 more file in changeset.
DEN-15921, DEN-15868 changed the direction of the pumps in RO permeate sample mode. Changed the code to check the flow in heat disinfect and active cool to only when the system is not hot

  1. … 3 more files in changeset.
DEN-15517 added an event to monitor the inactive data

DEN-15921 changed the active cool to transition to cancel water path instead of basic path when caps are not on

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 3 more files in changeset.
DEN-15736 updated the concentrate pumps to set the control bit if it is not the same as what it should be

  1. … 3 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-15867: Fix for issue where concentrate prime/test was being done twice in pre-tx.

Merged staging

  1. … 3 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 3 more files in changeset.
Merge branch 'DEN-15702-alarm-150-inlet-water-conductivity-high-does-not-disappear-on-standby-screen-when' into develop

  1. … 2 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 3 more files in changeset.
Changed the heat disinfect transfer rate from 800 mL/min to 500 mL/min

Merge branch 'staging' into DEN-15660-test_configuration_treatment_recovery

  1. … 2 more files in changeset.
Merge branch 'DEN-15660-test_configuration_treatment_recovery' into develop

DEN-15660 addressed the code review comments

  1. … 1 more file in changeset.
DEN-15660 addressed the code review comments

  1. … 1 more file in changeset.
DEN-15702 Check VPI Open for Inlet Conductivity, Pressure, temperature. If VPI Closed, clear alarms.

  1. … 3 more files in changeset.
Merge branch 'DEN-15660-test_configuration_treatment_recovery' into develop

DEN-15809 added code to clear the dialysate generation alarm 147

DEN-15809 updated the code to trigger another alarm if the empty bottle alarms have been triggered.:

Merge branch 'DEN-15660-test_configuration_treatment_recovery' into develop

DEN-15660, DEN-15781, added code to not check the dialysate temperature sensorswhen the dialysate flow is zero. DEN-15808, Added code to process the empty jug alarm

  1. … 1 more file in changeset.
Merge branch 'DEN-15660-test_configuration_treatment_recovery' into develop

  1. … 1 more file in changeset.
DEN-15660, DEN-15767, DEN-15781 cleaned up the SystemCommMessages.c for messages list script. Added moving average for TDi and TRo sensors for dialysate temperature drift check

  1. … 2 more files in changeset.
Merge branch 'DEN-15802-no-dg-flow-rate-out-of-range-alarms-191-192-for-heat-disinfect-active-cool' into develop

# Conflicts:

# firmware/App/DGCommon.h

Merge branch 'DEN-15660-test_configuration_treatment_recovery' into develop

DEN-15715 added a command to close VRD1 prior to transitioning to chemical disinfect cancel water path

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merge branch 'DEN-15691-heat-disinfect-reservoir-leak-alarm-triggers-after-5s-when-srsdg-512-and-521-say-it' into develop

Timeout increased from 5 to 10 seconds