Modes

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-15199 added to code to check for dialin check in

  1. … 5 more files in changeset.
DEN-15199 addressed the code review comments

  1. … 1 more file in changeset.
DEN-15199 renamed the test configuration code

  1. … 4 more files in changeset.
DEN-15199 worked on the release software configuration

  1. … 4 more files in changeset.
DEN-15199 updated the code per the systems requirements. Initial work on the release software configurations

  1. … 1 more file in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 12 more files in changeset.
Merge branch 'staging' into DEN-15166-add-drain-pump-maxon-board-rpm

Merge branch 'DEN-15178-heat-disinfect-drain-timeout-transition-to-cancel-water-path-instead-of-cancel' into develop

# Conflicts:

# firmware/App/DGCommon.h

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-15182 removed the rejection ratio alarm from the standby mode

DEN-15182 added a pause state in standby mode for the inlet water conditions. Addressed the code review comments

  1. … 4 more files in changeset.
DEN-13949 updated heat disinfect valves actuator per SRSDG 504

DEN-15182 updated the code to handle the inlet water conditions in standby mode

DEN-15166, DEN-15182 updated the voltages code and fixed the filter flush code to be able to resume after an inlet condition alarm

  1. … 1 more file in changeset.
DEN-15178 DrainR1, DrainR2 on timeout transition to Cancel Water Path

Fixed merge conflicts from DEN-15105.

  1. … 1 more file in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 3 more files in changeset.
DEN-15164 changed the inlet water conditions persistenet alarm to 30 seconds

  1. … 3 more files in changeset.
Merge branch 'DEN-15164-inlet-water-temp-alarm-closes-vpi' into develop

DEN-15164 removed the code to close VPi in filter flush mode when the inlet water condition is out of range

DEN-15077-fmp-flow-vs-load-cell-comparison-to-use-load-cells-as-actual-value

converted error relative to integrated flow, to error relative to load cell, as the load cell mass is a more accurate measurement.

Merged staging and resolved the conflicts

  1. … 3 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 10 more files in changeset.
DEN-14999 merged staging

  1. … 7 more files in changeset.
DEN-14999 updated the code based on the alarms table

  1. … 7 more files in changeset.
Merge branch 'DEN-14999-alarm-table-updates-part-2' into develop

DEN-14999 added 5-second delays prior to collecting acid and bicarb conductivity values during acid and bicarb priming

Changed the heat disinfect transfer flow to 0.5 L/min from 0.8 L/min

Merged staging

  1. … 5 more files in changeset.