Services

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14327 Clear Audio alarm when HD com reconnects in Fault mode.

Merge branch 'DEN-14197-sw-s83-mg-pi-optimizations' into develop

DEN-14197: Increased max RO control step size.

DEN-14197: Moved normal message out of Dialin handler section.

Fixed merge conflicts.

  1. … 5 more files in changeset.
DG-DEN-14316_Chemical Disinfect
DG-DEN-14316_Chemical Disinfect
DG-DEN-14307_DG HD Dev HD DG Dvt Update Part 6
DG-DEN-14307_DG HD Dev HD DG Dvt Update Part 6
Merged DEN-14237

  1. … 3 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 16 more files in changeset.
RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

DEN-14175 addressed the code review comments

  1. … 1 more file in changeset.
Done.

Done.

Done.

Done.

Isn't fpgaSensorReadings an input?

Isn't fpgaSensorReadings an input?

Restore or remove.

Restore or remove.

DEN-14175 created a getHWConfig in FPGA

DEN-14197: updated Dialin msg handling DIAL-200: Implemented handler for total fill volume override. Implemented fill mode broadcast override handler. DIAL-212: Implemented RO feedback voltage override handler.

  1. … 2 more files in changeset.
DEN-14175 updated the extra temperature to 0.0 from 2.0

DEN-14197: implemented RO pump profile switching. Implemented Flow to PWM function RO pump with profiles as a parameter. Created a SW fault for PI profiles out of range.

  1. … 2 more files in changeset.
DEN-14197: Initial attempt at PI controller profiles with usage in ro pump

  1. … 1 more file in changeset.
Merge branch 'DEN-14175-dg_hd_dev-hd_dg_dvt-update-part-5' into develop

  1. … 3 more files in changeset.
RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

DEN-14175 addressed the code review comments and replaced the V3 enable software configuration flag with the hardware configuration flag from FGPA. Updated the trimmer heater's ramp state to check the use previous duty cycle flag instead of estimating the duty cycle.

  1. … 14 more files in changeset.
This is done to get an average of the fill temperature as well as the last fill temperature prior to tranistioning to Gen Idle. These values are used for the next estimation and are different from ...

This is done to get an average of the fill temperature as well as the last fill temperature prior to tranistioning to Gen Idle. These values are used for the next estimation and are different from the heaters driver.

Done.

Done.