Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DENBUG-320 addressed a code review comment

DENBUG-320 brought back the start fill command after removing alarms 281, 282

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Resolved merge conflicts from DENBUG-318

DENBUG-318 added the word max to the RO rejection ratio

DENBUG-320 added the word max to the RO rejection ratio

DENBUG-320 removed the code that checked for the acid and bicarb low volume and triggered alarms

DENBUG-318 added an event for RO rejection ratio from HD institutional record

DENBUG-318 added code to request and receive the RO rejection ratio from the HD institutional record and apply it in the mode fill

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged release/p1b/staging

    • -10
    • +23
    ./Controllers/ConcentratePumps.c
    • -7
    • +42
    ./Modes/ModeHeatDisinfectActiveCool.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DENBUG-298 updated the code from staging

    • -10
    • +23
    ./Controllers/ConcentratePumps.c
    • -7
    • +42
    ./Modes/ModeHeatDisinfectActiveCool.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DENBUG-307-concentrate-pump-tube-ruptures-during-heat-disinfection-staging' into develop

DENBUG-307 updated the active cool mode to set the actuators prior to transitioning to complete state

DEN-17263 addressed the code review comments

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DENBUG-307 updated the active cool to run the concentrate pumps for a few seconds at the end of the mode

    • -23
    • +50
    ./Modes/ModeHeatDisinfectActiveCool.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DENBUG-307-concentrate-pump-tube-ruptures-during-heat-disinfection-staging' into develop

DENBUG-307 changed the heat disinfect active cool to run the concentrate pumps during the final reservoir drains

    • -12
    • +19
    ./Modes/ModeHeatDisinfectActiveCool.c
DENBUG-314 added more comment

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DENBUG-307-concentrate-pump-tube-ruptures-during-heat-disinfection-staging' into develop

DEN-17263 fixed the code to check the direction of the concentrate pumps and then decide based on that whether the measured speed values being negative or positive is correct or not