firmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14646 Use typedefs in voltages.c to improve debugging. Correct counting FPGA timeouts twice if write values ACK not received. Correct handling of emstat response status values.

    • -14
    • +49
    ./App/Controllers/ConductivitySensors.c
Fixed. Thanks!

Fixed. Thanks!

Fixed. Thanks!

Fixed. Thanks!

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DEN-14689-messaging-bugs' into develop

DEN-14689: sync msg_ids with msgdefs.h

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merge branch 'staging' into DEN-14763-dg_hd_dev-hd_dg_dvt-update-part-10

    • -2
    • +2
    ./App/Modes/ModeChemicalDisinfectFlush.c
DG-DEN-13154_Heparin Syringe Empty Position Incorrect
DG-DEN-13154_Heparin Syringe Empty Position Incorrect
DEN-13154: Added raw flow rates to DG flow broadcast messages.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

    • -1
    • +1
    ./App/Controllers/TemperatureSensors.c
RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

In common.h to be used by both stacks.

In common.h to be used by both stacks.

Where did this go?

Where did this go?

DEN-14834 updated the code to just send the heater command in Idle and Drain if the primary heater is not on. Addressed the code review comments

Done.

Done.

Done.

Done.

Done

Done

Remove blank line.

Remove blank line.

Comments for these target flows should explain why they're here (instead of just getting flow from flow module).

Comments for these target flows should explain why they're here (instead of just getting flow from flow module).