Modes

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-13460 added PiSquare VectorCAST

  1. … 1 more file in changeset.
DEN-13801: updated pressure values for Dry Self Test for both arterial and venous that are achievable within the time frame that blood pump runs.

DEN-13801: Decay State of Dry Self Tests now updates the peak pressure value after pump has stopped due to filter lag.

DEN-13598 updated the code

  1. … 4 more files in changeset.
Keep this blank line. Separate declarations from code.

Keep this blank line. Separate declarations from code.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 7 more files in changeset.
DEN-13427: post merge changes for staging

  1. … 2 more files in changeset.
RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Remove blank line.

Remove blank line.

Merge branch 'staging' into DEN-13427-sw_dev-sprint-75_mg

  1. … 1 more file in changeset.
Fixed. Thanks!

Fixed. Thanks!

Fixed. Thanks!

Fixed. Thanks!

Fixed. Thanks!

Fixed. Thanks!

DEN-13427: Addressed code review comments

Merged DEN-13834

  1. … 11 more files in changeset.
DEN-13834 added the DG heaters broadcast message. Addded a function to check the status of the trimmer heater's state in DGInterface and keep sending the command from HD until the trimmer heater is in the right status. Enabled stop/start trimmer command in the modes

  1. … 6 more files in changeset.
I think the style is to use set/get functions if needed by other modules, otherwise just access the variable directly.

I think the style is to use set/get functions if needed by other modules, otherwise just access the variable directly.

Need to initialize here at declaration or in init function. I see neither now.

Need to initialize here at declaration or in init function. I see neither now.

DEN-13460 addressed the code review comments

  1. … 12 more files in changeset.
Thanks for the reminder.

Thanks for the reminder.

Done.

Done.

Done.

Done.

Done.

Done.

Done.

Done.

Done.

Done.