firmware

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14788: code review comments.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-14906: Increased pump speed during dialyzer re-prime and reduce time in re-prime state in attempt to address over-current alarm.

DEN-14999: Reduced BP occlusion clear threshold from 5500 to 5000 above baseline.

HD-DEN-14999_Alarm Table Updates
HD-DEN-14999_Alarm Table Updates
Merge branch 'staging' into DEN-14788-DIAL-242-air-bubble-sensor

    • -6
    • +134
    ./App/Services/SystemCommMessages.c
DEN-14788: fixed UI check-in.

DEN-14860 Fix config bug. If Dry tests disabled, got stuck in Prime because DG Allow Flush/Fill signals not set.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

HD-DEN-14457_Reservoir Drains Before Treatment With Pre Treatment Build Flags Off

Updated signalAllowDGFlushFills(),

signalAllowDGFillRes[12]() to be sure that the signal to continue occurs even when both thr air pump and dry tests are disabled.

Add timeWaitToFillMS to header.

Add timeWaitToFillMS to header.

Aligned memory with sector boundaries

Aligned memory with sector boundaries

Aligned memory with sector boundaries

HD-DEN-14788_DIAL_242 Air Bubble Sensor
HD-DEN-14788_DIAL_242 Air Bubble Sensor
Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-14788: DIAL-242: added check for bubble sensor override.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-14906: Added delay before resuming dialyzer re-prime to allow DPi to stop to prevent pressure spike.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

HD-DEN-14888_Unable TO Trigger Alarm 47 Ultrafiltration Rate IS Too High Error During Treatment2
HD-DEN-14888_Unable TO Trigger Alarm 47 Ultrafiltration Rate IS Too High Error During Treatment2
DEN-14888: Fix issue with initializing start/final reservoir volumes.