Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14834 updated that get target primary heater function to accomodate the changes from pre-treatment. Removed the range check from the drain pump measured RPM

  1. … 4 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 1 more file in changeset.
DEN-14788: code review comments

DEN-14834 updated the code to not check the rejection ratio and CPo if the target fill is less than 550 mL. Updated the heaters code to make sure the stop heaters command stops the heaters unless a new start command is issued

  1. … 1 more file in changeset.
Merge branch 'staging' into DEN-14646-fpga-alarm-properties-and-timing-3

DEN-14788: Fixed heaters duty cycle override to immediately set PWM instead of waiting for control state machine to set PWM.

Merge branch 'DEN-14789-sw-cp-persistence-timer-increase' into develop

  1. … 4 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 7 more files in changeset.
DEN-14781 changed the drain pump flow control interval and the trimmer heaters minimum flow rate

  1. … 1 more file in changeset.
DEN-14781 updated Nelson support

  1. … 3 more files in changeset.
Merge branch 'staging' into DEN-14646-fpga-alarm-properties-and-timing-3

DEN-14646 - Remove checking the error counter for persistent alarms that previously generated alarms based upon the read counter and the error counter.

  1. … 3 more files in changeset.
Merge branch 'DEN-14589-DIAL-211' into develop

  1. … 2 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14760 changed the minimum dialysate flow rate of the trimmer heater to alarm.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 1 more file in changeset.
DEN-13972 added a #define for the delta temperature in the heaters

DEN-13972 changed the code in the heaters to consider if the temperatures are negative and therefore the duty cycle is not set to positive artificially

Fixed merge conflict.

  1. … 6 more files in changeset.
Fixed merge conflicts.

  1. … 6 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 15 more files in changeset.
DEN-14604 added Nelson labs heat disinfect positive control mode

  1. … 5 more files in changeset.
DEN-14604 work in progress. Tested and updated the Nelson support

  1. … 6 more files in changeset.
DEN-14604 updated the code to be able to use multiple heat disinfect timers per the new requirements

  1. … 4 more files in changeset.
Merge branch 'DEN-13946-certain-temperature-sensors-trigger-wrong-alarm' into develop

# Conflicts:

# firmware/App/DGCommon.h

  1. … 8 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 23 more files in changeset.
DEN-14497 addressed the code review comment

Merge branch 'staging' into DEN-14497-dg_hd_dev-hd_dg_dvt-update-part-7

  1. … 23 more files in changeset.
DEN-14497 addressed the code review comments

  1. … 6 more files in changeset.
Fixed merge conflicts.

  1. … 22 more files in changeset.