hdfirmware

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DIAL-262: fixes

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DIAL-262: added additional event calls for UF and saline transitions.

DEN-15367 addressed the code review comments. Added code to check the payload of the message that is received from DG to indicate that DG is ready to dispense more water in RO permeate sample mode

DEN-15558: Addressed code review comment.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Merge branch 'DEN-15196-DIAL-262-fixes' into develop

DIAL-262: removed old 4th state data when hd pauses in priming

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Merge branch 'DEN-15558-fw-system-does-not-widen-venous-pressure-range-when-filling-air-trap-vbt-open-in' into develop

    • -19
    • +31
    /firmware/App/Controllers/PresOccl.c
DEN-15558: Extend exemption for venous low pressure alarm during air trap fill for 5 seconds after fill to allow pressure to recover.

    • -17
    • +29
    /firmware/App/Controllers/PresOccl.c
Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merge branch 'DEN-15363-fw-handle-bld-sensor-communication-errors' into staging

    • -5
    • +12
    /firmware/App/Controllers/BloodLeak.c
Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-15558: Finished restore of original BP speed during dialyzer prime.

Merge branch 'DEN-15196-DIAL-262-fixes' into develop

DIAL-262: fixed operation status event to have more accurate transitioning in between dialysis sub modes.

DEN-15558: Reversed temporary change in dialyzer prime BP speed. Increased max venous pressure from 300 to 400 mmHg.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Fixed merge conflict.

DEN-15558: temporary slow down of BP during pre-tx dialyzer prime state to see if helps with blood leak issue.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Merged DEN-15459

    • -2
    • +2
    /firmware/App/Controllers/DialInFlow.c
Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DEN-15459

DEN-15459 changed the blood leak alarm detection to not trigger if the HD mode is not in treatment

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

    • -2
    • +2
    /firmware/App/Controllers/DialInFlow.c
    • -1
    • +1
    /firmware/App/Controllers/DialInFlow.h
    • -2
    • +2
    /firmware/App/Controllers/DialOutFlow.c
    • -1
    • +1
    /firmware/App/Controllers/DialOutFlow.h