TDInterface.h

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Are we done testing? Can we remote test variables and code?

Are we done testing? Can we remote test variables and code?

LEAHI-DD-FIRMWARE-LDT-5209_Pre-Treatment - FW Implementation - 9/6:
LEAHI-DD-FIRMWARE-LDT-5209_Pre-Treatment - FW Implementation - 9/6:
added

added

removed

removed

updated

updated

updated

updated

done

done

updated.

updated.

added

added

Add comment.

Add comment.

Initialize these in init function.

Initialize these in init function.

update input section (for the prime fluid discard status)

update input section (for the prime fluid discard status)

Remove empty line

Remove empty line

Remove this commented code.

Remove this commented code.

Add comment.

Add comment.

Add comments.

Add comments.

updated

updated

updated

updated

updated

updated

2.0 PSI?

2.0 PSI?

Add comment. Also add parenthesis for multiplication.

Add comment. Also add parenthesis for multiplication.

Do we want to increase to higher - 1.0F?

Do we want to increase to higher - 1.0F?

My understanding is that Standby should stop all pumps and heaters, including D108. Although the D108 driver implementation is not available yet, I thought keeping this call would preserve the inte...

My understanding is that Standby should stop all pumps and heaters, including D108. Although the D108 driver implementation is not available yet, I thought keeping this call would preserve the intended Standby behavior and allow it to work once driver support is added. Could you please let me know if there is any concern with leaving it in place for now?

Michael confirmed that FP will eventually support two firmware-controlled sampling modes: Filter Sample and RO Permeate Sample. Since the flow paths are not defined yet, we will keep a generic plac...

Michael confirmed that FP will eventually support two firmware-controlled sampling modes: Filter Sample and RO Permeate Sample. Since the flow paths are not defined yet, we will keep a generic placeholder for the sampling mode/state and update the implementation and requirements once the feature is better defined.

LEAHI-DD-FIRMWARE-LDT-5409_(DD) Balancing Chamber stops during dialysate generation
LEAHI-DD-FIRMWARE-LDT-5409_(DD) Balancing Chamber stops during dialysate generation
LEAHI-DD-FIRMWARE-LDT-4873_(Request) Add config to disable conductive level sensor fault
LEAHI-DD-FIRMWARE-LDT-4873_(Request) Add config to disable conductive level sensor fault
LEAHI-DD-FIRMWARE-LDT-5102_DD: Concentrate Pumps Hardware Driver Update
LEAHI-DD-FIRMWARE-LDT-5102_DD: Concentrate Pumps Hardware Driver Update
renamed. thanks!

renamed. thanks!

renamed

renamed