FPModes

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
instead of 0, we can use the level Enum 'LVL_STATE_EMPTY'?

instead of 0, we can use the level Enum 'LVL_STATE_EMPTY'?

lower? and change the D98 level sensor comment as well.

lower? and change the D98 level sensor comment as well.

Remove empty line

Remove empty line

Space before LVL_STATE_LOW

Space before LVL_STATE_LOW

space inside array index.

space inside array index.

Space inside parenthesis.

Space inside parenthesis.

Change this to LEVEL_T enum.

Change this to LEVEL_T enum.

Is this macro still being used? if not, delete it.

Is this macro still being used? if not, delete it.

LEAHI-DD-FIRMWARE-LDT-3978_Switch Chamber F conductive level sensors to broadcast 1 as sensing liquid
LEAHI-DD-FIRMWARE-LDT-3978_Switch Chamber F conductive level sensors to broadcast 1 as sensing liquid
fixed

fixed

Align the comments.

Align the comments.

LEAHI-DD-FIRMWARE-LDT-3984_(DD, SW) D46 reads 0 with and without liquid in chamber
LEAHI-DD-FIRMWARE-LDT-3984_(DD, SW) D46 reads 0 with and without liquid in chamber
COMM_BUFFER_OUT_CAN_FP_BROADCAST sendEvent check the event ID. if it is an FP event, FP event will be sent on COMM_BUFFER_OUT_CAN_FP_BROADCAST

COMM_BUFFER_OUT_CAN_FP_BROADCAST

sendEvent check the event ID. if it is an FP event, FP event will be sent on COMM_BUFFER_OUT_CAN_FP_BROADCAST

Do we know which channel this event will be sent on?

Do we know which channel this event will be sent on?

LEAHI-DD-FIRMWARE-LDT-3904_[OpMode] The operation mode broadcasts does not return the 3rd and 4th level modes
LEAHI-DD-FIRMWARE-LDT-3904_[OpMode] The operation mode broadcasts does not return the 3rd and 4th level modes
LEAHI-DD-FIRMWARE-LDT-3677_Request: add SW config to enable defeatured IOFP control in the IOFP FW
LEAHI-DD-FIRMWARE-LDT-3677_Request: add SW config to enable defeatured IOFP control in the IOFP FW