leahi-common

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
LDT-473 addressed review comments and removed prime discard volume from msg payload

No we are not getting conv factor from UI on it I will have to confirm with Nick to see if we will get the bicarbConvFactor

No we are not getting conv factor from UI on it
I will have to confirm with Nick to see if we will get the bicarbConvFactor

Balancing chamber switching control

Balancing chamber switching control

Can this statement be 'else if' case after BC switch only request handling (after line 1013). Just in case both requests (switch only and regular one) came together and only 'switch only' handled f...

Can this statement be 'else if' case after BC switch only request handling (after line 1013). Just in case both requests (switch only and regular one) came together and only 'switch only' handled first.

remove the space before false.

remove the space before false.

Remove blank line

Remove blank line

Remove blank line.

Remove blank line.

Align comments.

Align comments.

Can we just remove this?

Can we just remove this?

Can we just remove this?

Can we just remove this?

F suffix.

F suffix.

Is bicarbonate also a conversion factor?

Is bicarbonate also a conversion factor?

Can we just remove the old enum now?

Can we just remove the old enum now?

I tried the suggested change and tested. But it did not provide the expected results. If a on was requested while an off was still pending to be processed, the off-request flag gets cleared without...

I tried the suggested change and tested. But it did not provide the expected results.
If a on was requested while an off was still pending to be processed, the off-request flag gets cleared without the actual request being processed and the off request was never executed.

LDT-473 initial draft WIP new tx params message payload

Not sure these min/max are right here either.

Not sure these min/max are right here either.

So we have all temp sensors getting averaged now, right? So should we have one get function that takes a sensor ID as param?

So we have all temp sensors getting averaged now, right? So should we have one get function that takes a sensor ID as param?

Remove extra blank lines.

Remove extra blank lines.

LEAHI-TD-FIRMWARE-LDT-473_Treatment Parameters (Create Rx) - TD - 04: DEV - Feature Implementation
LEAHI-TD-FIRMWARE-LDT-473_Treatment Parameters (Create Rx) - TD - 04: DEV - Feature Implementation
LDT-473 initial draft WIP new tx params message payload

LDT-3352 reolving merge conflicts

Done.

Done.

Done

Done

Done.

Done.

LDT-3352 heater control update