leahi-common

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Fixed

Merge branch 'LDT-1886-blood-set-auto-load-and-auto-ej' into develop

Updated

Updated

Removed

Removed

resolved merge conflicts and merged LDT-1886

Fixed

Fixed

Removed

Removed

Added alarm

Added alarm

Added back

Added back

Added alarm

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merge branch 'staging' of bitbucket.org:diality-cloud/leahi-common into LDT-4033-patient-vitals-fw-implementation

Merge branch 'staging' into LDT-1886-blood-set-auto-load-and-auto-ej

Add alarm here.

Add alarm here.

Make h10DACControl a U08.

Make h10DACControl a U08.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Remove extra blank line.

Remove extra blank line.

This looks like leftover from merge conflict. Remove this line.

This looks like leftover from merge conflict. Remove this line.

What do we do if BP module reports an error? Do we just go to idle state and there is no alarm?

What do we do if BP module reports an error? Do we just go to idle state and there is no alarm?

resolved merge conflicts and merged LDT-3963

Merge branch 'staging' of bitbucket.org:diality-cloud/leahi-common into LDT-3215-measured-venous-pressure-decreases

Thats for error register so not required now

Thats for error register so not required now

You’re right. I should also check the busy status before transitioning to the GET_DATA state. I’ll update the measurement completion logic to first verify the busy bit is cleared, then validate the...

You’re right. I should also check the busy status before transitioning to the GET_DATA state. I’ll update the measurement completion logic to first verify the busy bit is cleared, then validate the BP data response code before moving to BP_DRIVER_GET_DATA_STATE.

Merge branch 'staging' into feature/LDT-3963-dialysate-flow-rate---fw-implem

LDT:3970 Merge Latest From Staging

LDT:3970 Updated Edit Treatment Parameters