OperationModes.c

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
LEAHI-DD-FIRMWARE-LDT-3749_Ability to set operation sub mode on DD subsystem
LEAHI-DD-FIRMWARE-LDT-3749_Ability to set operation sub mode on DD subsystem
LEAHI-DD-FIRMWARE-LDT-2004_Dialysate Composition - DD
LEAHI-DD-FIRMWARE-LDT-2004_Dialysate Composition - DD
LEAHI-DD-FIRMWARE-LDT-2004_Dialysate Composition - DD
LEAHI-DD-FIRMWARE-LDT-2004_Dialysate Composition - DD
LEAHI-DD-FIRMWARE-LDT-3749_Ability to set operation sub mode on DD subsystem
LEAHI-DD-FIRMWARE-LDT-3749_Ability to set operation sub mode on DD subsystem
LEAHI-DD-FIRMWARE-LDT-3627_[FP/DD VALVES] The valves sensed state values in the broadcast are always 1
LEAHI-DD-FIRMWARE-LDT-3627_[FP/DD VALVES] The valves sensed state values in the broadcast are always 1
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 121 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 121 more files in changeset.
LDT-2198 was merged into this branch after being merged into staging_alpha. Branch will be killed and relevant code changes were reviewed appropriately.

LDT-2198 was merged into this branch after being merged into staging_alpha. Branch will be killed and relevant code changes were reviewed appropriately.

Done.

Done.

RESOLVED IN CODE WALKTHROUGH.

RESOLVED IN CODE WALKTHROUGH.

Done

Done

Done

Done

Done

Done

Done

Done

Done

Done

Appears to be dialysate to dialyzer flow rate.

Appears to be dialysate to dialyzer flow rate.

Looking at the implementation of this function, it appears that this function is setting dialysateFlowRate to target rate only when delivering dialysate to the dialyzer and to zero in all other cas...

Looking at the implementation of this function, it appears that this function is setting dialysateFlowRate to target rate only when delivering dialysate to the dialyzer and to zero in all other cases. Consider changing variable name to something like dialysateToDialyzerFlowRate and updating function description in header to make this more clear.

0.0F.

0.0F.

Check the current Gen dialysate sub state.

Check the current Gen dialysate sub state.

Please use 0.0F (since its float variable).

Please use 0.0F (since its float variable).

LEAHI-DD-FIRMWARE-LDT-1196_DD: Request for a variable for target Qd rate
LEAHI-DD-FIRMWARE-LDT-1196_DD: Request for a variable for target Qd rate