MsgDefs.h

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
LDT-2008: added alarms and msg ids for version request. alarms are for cond sensor faults.

  1. … 1 more file in changeset.
Merge branch 'staging' into LDT-2008-v2-conductivity-sensors-CLEAN

LEAHI-DD-FIRMWARE-LDT-3735_System Data and Logs - DD - Non-Volatile Memory - 04: DEV - Feature Implementation
LEAHI-DD-FIRMWARE-LDT-3735_System Data and Logs - DD - Non-Volatile Memory - 04: DEV - Feature Implementation
LDT-473 added new UF volume and weights inconsistency rejection

Is it an enum/index like Denali then?

Is it an enum/index like Denali then?

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

LDT-3676 resolved merge commit with develop

LDT-3676 resolved merge conflict

LEAHI-DD-FIRMWARE-LDT-3749_Ability to set operation sub mode on DD subsystem
LEAHI-DD-FIRMWARE-LDT-3749_Ability to set operation sub mode on DD subsystem
LDT-3749 added DD set operation sub mode override msg

No we are not getting conv factor from UI on it I will have to confirm with Nick to see if we will get the bicarbConvFactor

No we are not getting conv factor from UI on it
I will have to confirm with Nick to see if we will get the bicarbConvFactor

Align comments.

Align comments.

Can we just remove this?

Can we just remove this?

Can we just remove this?

Can we just remove this?

F suffix.

F suffix.

Is bicarbonate also a conversion factor?

Is bicarbonate also a conversion factor?

Can we just remove the old enum now?

Can we just remove the old enum now?

LDT-473 initial draft WIP new tx params message payload

Not sure these min/max are right here either.

Not sure these min/max are right here either.

So we have all temp sensors getting averaged now, right? So should we have one get function that takes a sensor ID as param?

So we have all temp sensors getting averaged now, right? So should we have one get function that takes a sensor ID as param?

Remove extra blank lines.

Remove extra blank lines.

LEAHI-TD-FIRMWARE-LDT-473_Treatment Parameters (Create Rx) - TD - 04: DEV - Feature Implementation
LEAHI-TD-FIRMWARE-LDT-473_Treatment Parameters (Create Rx) - TD - 04: DEV - Feature Implementation
LDT-473 initial draft WIP new tx params message payload

  1. … 1 more file in changeset.
LDT-3352 reolving merge conflicts

Done.

Done.